An Experimental Study of Conducted EMI Mitigation on the LED Driver using Spread Spectrum Technique

Authors

  • Mohammad Yanuar Hariyawan Politeknik Caltex Riau
  • Risanuri Hidayat Gadjah Mada University
  • Eka Firmansyah Gadjah Mada University

Abstract

LED driver has the potential to interfere the system of electronic devices if the voltage and current change rapidly.  Several previous studies presented various solutions to overcome this problem such as particular converter design, component design, electromagnetic interference (EMI) filters, and spread-spectrum techniques. Compared to other solutions, the spread-spectrum technique is the most potential way to reduce the EMI in LED applications due to its limited cost-size-weight. In this paper, the effectiveness of conducted EMI suppression performance and the evaluation of its effect on LED luminance using spread-spectrum techniques are investigated. Spread-spectrum is applied to the system by modifying the switching frequency by providing disturbances at pin IADJ. The disorder is given in the form of four signals, namely square, filtered-square, triangular, and sine disturbance signals. The highest level of the EMI suppression of about 31.89% is achieved when the LED driver is given 800 mVpp filtered-square waveform. The highest reduction power level occurs at fundamental frequency reference, when it is given 700 mVpp square disruption signal, is about 81.77% reduction. The LED luminance level will reduce by 85.2% when it is given the four waveforms disruption signals.  These reductions occur as the switching frequency of the LED driver does not work on a fixed frequency, but it varies in certain bands. LED brightness level has a tendency to generate a constant value of 235 lux when it is given the disruption signals. This disturbance signal causes the dimming function on the system that does not work properly.

Author Biographies

Mohammad Yanuar Hariyawan, Politeknik Caltex Riau

D4 Teknik Elektronika Telekomunikasi

Risanuri Hidayat, Gadjah Mada University

Department of Electrical Engineering and Information Technology

Eka Firmansyah, Gadjah Mada University

Department of Electrical Engineering and Information Technology

References

M. S. Shur and A. Zukauskas, "Solid-State Lighting: Toward Superior Illumination," Proceedings of the IEEE, vol. 93, pp. 1691-1703, 2005.

I. L. Azevedo, M. G. Morgan, and F. Morgan, "The Transition to Solid-State Lighting," Proceedings of the IEEE, vol. 97, pp. 481-510, 2009.

W. R. Ryckaert, K. A. G. Smet, I. A. A. Roelandts, M. Van Gils, and P. Hanselaer, "Linear LED Tubes Versus Fluorescent Lamps: An Evaluation,"Energy and Buildings, vol. 49, pp. 429-436, 2012.

A. D. N. Ndokaj, A., "LED Power Supply and EMC Compliance," Energy Conference and Exhibition (ENERGYCON) IEEE International, pp. 254 - 258, 2012.

C. Qi, C. Quan, and L. Xiaobing, "Fast Estimation of LED's Accelerated Lifetime by Online Test Method," Electronic Components and Technology Conference (ECTC), pp. 1992-1995,2014.

Z. J. H. Z. L. Shengqian, "System Level Design of A LED Lighting Driver Based on Switching Power Supply," Microelectronics & Electronics, 2009. PrimeAsia 2009. Asia Pacific Conference on Postgraduate Research, pp. 309-312, 2009.

S. P. Y. C.-W. T. B.-J. Huang, "Characterizing LEDs for Mixture of Colored LED Light Sources,” Electronic Materials and Packaging, 2006. EMAP 2006. International Conference on, Kowloon, pp. 1-5, 2006.

S.-C. H. L.-L. L. M.-S. J. Y.-C. Hsieh, " Assessment of Energy-Efficient LED Street Lighting Through Large-Scale Demonstration," Renewable Energy Research and Applications (ICRERA), pp. 1 - 5, 2012.

C. P. X. L. P. Z. L. X. X. Liu, "RGB High Brightness LED Modules for Projection Display Application," Display Technology, vol. 7, pp. 448 - 453, 2011.

T.-F. C. Wu, C.-C.; Wu, C.-Y. ; Lu, P.-C. ; Chen, Y.-R. , "Sequential Color LED Backlight Driving System for LCD Panels with Area Control,"Power Electronics Specialists Conference, 2007. PESC 2007, Orlando, FL pp. 2947 - 2952, 2007.

L. Dong, Y. Ye, and L. He, "A Novel PWM Controller IC for LED Driver with Frequency Spread," Power and Energy Engineering Conference (APPEEC), 2010 Asia-Pacific, pp. 1-4,2010.

D. G. Lamar, J. Sebastian, M. Arias, and M. M. Hernando, "A Low-Cost AC-DC High-Brightness LED Driver with Power Factor Correction Based on Standard Peak-Current-Mode Integrated Controllers,"Energy Conversion Congress and Exposition (ECCE), 2010 IEEE, pp. 463-470, 2010.

K. O. Mainali, R. , "Conducted EMI Mitigation Techniques for Switch-Mode Power Converters A Survey," Power Electronics, IEEE Transactions vol. 25, pp. 2344 - 2356, 2010.

S.-M. W. K.-H. Chang, "An LED Driver with Active EMI Mitigation Scheme," Electron Devices and Solid-State Circuit (EDSSC), pp. 1-4,2012.

W. A. Junying Niu; Yuhong Song; Zhong Li; Halang, "Reducing EMI in Half-Bridge Resonant LED Drivers with Chaos-based PWM," Electromagnetic Compatibility (EMC EUROPE), 2013 International Symposium, pp.637-640, 2013.

H. Wong, Y. Chan, and S. W. Ma, "Electromagnetic Interference of Switching Mode Power Regulator with Chaotic Frequency Modulation," Microelectronics, 2002. MIEL 2002. 23rd International Conference, pp. 577-580, 2002.

Y. Liu and Y. Jinming, "The Topologies of White LED Lamps' Power Drivers," Power Electronics Systems and Applications, 2009. PESA 2009. 3rd International Conference, pp. 1-6, 2009.

G. C. Pasetti, N.; Tinfena, F.; Serventi, R.; D'Abramo, P.; Saponara, S.; Fanucci, L., "Characterization of An Intelligent Power Switch for LED Driving with Control of Wiring Parasitics Effects,"Design, Automation & Test in Europe Conference & Exhibition (DATE), pp.1-2, 2011.

M. R. Cosetin, P. C. V. Luz, M. F. da Silva, F. Bisogno, J. M. Alonso, and R. N. do Prado, "Single-Stage Sepic-Buck Converter for LED Lighting wth Reduced Storage Capacitor," IECON 2012 - 38th Annual Conference on IEEE Industrial Electronics Society pp. 4597-4603, 2012.

M. R. Cosetin, P. C. V. Luz, M. F. da Silva, F. Bisogno, J. M. Alonso, and R. N. do Prado, "LongLifetime SEPIC-Buck Integrated Converter for LED Lighting Application,"Industry Applications (INDUSCON), 2012 10th IEEE/IAS International Conference, pp. 1-7,2012.

M. R. Cosetin, P. C. V. Luz, E. A. Bitencourt, M. F. da Silva, F. Bisogno, J. M. Alonso, et al., "O-Line Single-Stage SEPIC-Buck Converter for Dimmable LED Lighting with Reduced Storage Capacitor," Power Electronics and Applications (EPE), 2013 15th European Conference,pp. 1-10,2013.

K. Junsik, L. Jiyong, and P. Shihong, "A Soft Self-Commutating Method using Minimum Control Circuitry for Multiple-String LED Drivers,"Solid-State Circuits Conference Digest of Technical Papers (ISSCC), 2013 IEEE International, pp. 376-377, 2013.

W. A. Venturini, E. A. Bitencourt, M. E. Schlittler, M. F. da Silva, R. N. do Prado, and F. E. Bisogno, "Analysis and Design Methodology of A Self-Oscillating System Based on Integrated Sepic Half-Bridge for LED Lightning Applications,"Power Electronics Conference (COBEP), 2013 Brazilian, pp. 1120-1127,2013.

Y. Yang, R. Xinbo, Z. Li, H. Jiexiu, and Y. Zhihong, "A Feed-Forward Scheme for an Electrolytic Capacitor-Less AC/DC LED Driver to Reduce Output Current Ripple," Power Electronics, IEEE Transactions, vol. 29, pp. 5508-5517, 2014.

A. K. R. Rasheed;, "Double Stage Buck Boost Converter For LED Lighting Application," International Conf. on Electrical, Electronics, Mechanical & Computer Engineering, Cochin, India, pp. 22-29,2014.

Y.-z. Xu, W.-m. Lin, Y.-c. Xu, and Y.-j. Shao, "Inductor Optimize Design for BCM BUCK-PFC in LED Driver,"Electric Information and Control Engineering (ICEICE), pp. 2264-2267, 2011.

Nielsen, M. A. E. Andersen, and K. S. Meyer, "Preliminary Investigations of Piezoelectric Based LED Luminary," Power Electronics and Applications (EPE 2011), Proceedings of the 2011-14th European Conference, pp. 1-9, 2011.

L. Keon, L. Dong-Hun, Y. Su-hun, P. Ji-Hyun, and Y. Kwang-Sub, "Design of High Dimming Ratio Power-LED Driver with Preloading Inductor Current Methodology, "SoC Design Conference (ISOCC), pp. 9-12, 2012.

G. M. Soares, P. S. Almeida, D. P. Pinto, and H. A. C. Braga, "A Single-Stage High-Efficiency Long-Life Off-Line LED Driver Based on The DCM Cuk Converter," IECON 2012 - 38th Annual Conference on IEEE Industrial Electronics Society, pp. 4509-4514, 2012.

[30] C. Jettanasen and C. Pothisarn, "Analytical Study of Harmonics Issued from LED Lamp Driver,"Proceedings of the International MultiConference of Engineers and Computer Scientists, Hong Kong, 2014.

L. Svilainis, "LED Brightness Control for Video Display Application," Displays, vol. 29, pp. 506-511, 2008.

J.-H. Ahn, "Implementation Of An Led Tile Controller for High-Quality Image Display," Displays, vol 34, pp. 17-26, 2013.

D. Gonzalez, J. Balcells, A. Santolaria, J. C. Le Bunetel, J. Gago, D. Magnon, et al., "Conducted EMI Reduction in Power Converters by Means of Periodic Switching Frequency Modulation," Power Electronics, IEEE Transactions, vol. 22, pp. 2271-2281, 2007.

Downloads

Published

2016-09-08

Issue

Section

Electromagnetic Compatibility